Spray Foam Insulation in Myrtle Grove, FL

Spray Foam Insulation in Myrtle Grove mostly means working on houses that have stood for decades. This community west of Pensacola already had 16,186 residents in 1970, and the 2020 census counted 17,224, so most of its homes predate the newer subdivisions farther out. In 2000 the area had 6,811 housing units; by 2020 there were 7,176. That slow growth means the typical house here is an older ranch with its original attic and ductwork, often with insulation that has been walked on, wet or packed down over the years.

The attic is the priority

In a single-story ranch on a slab, the attic is where most of the summer heat gets in. Old fill may be only a few inches deep, and the gaps around plumbing vents, light fixtures, the hatch and the tops of interior walls let hot attic air leak down into the house. DOE suggests R-38 to R-49 added over 3 to 4 inches of existing insulation for a Zone 2 home, and Escambia County is in Zone 2A on OpenEI's IECC list. We seal first, then bring the depth up, or we foam the roofline if the ducts and air handler are up there and in need of help.

Ducts that sweat

Old duct runs in a hot, humid attic can sweat and drip, staining ceilings. If the duct jackets are torn or thin, we point it out and recommend repairs by an HVAC contractor before we cover anything. Sealing the attic with foam is another way to stop the sweating because the ducts end up in milder, drier air.

Additions and garage conversions

Older homes often have a converted garage or a room added on the back. Those spaces commonly run hotter than the rest of the house because their walls, ceilings or floors were insulated differently. Spray foam is well suited to closing up an addition's ceiling or a converted garage's walls during a remodel.

Testing what you already have

Before we recommend anything in an older Myrtle Grove attic, we look at what is already up there. Many attics have a layer of loose fill that has settled to a fraction of its original depth, with matted spots where people walked to reach the air handler. Some have old batts laid between the joists with gaps at every edge. A few have pebbly vermiculite, which should be tested for asbestos before it is disturbed. If the existing insulation is dry and clean, we leave it, seal around it and add on top. If it is fouled or wet, we take it out first. Either way, a walkway to the air handler is kept clear so service visits do not crush the new insulation.

Removal before replacement

If the attic insulation is fouled by rodents or was soaked during a storm, it should be removed first. We price removal and new insulation as separate lines so you can see each cost.

Call or send the form to set up a visit. Get a free estimate