Spray Foam Insulation in Ensley, FL

Spray Foam Insulation in Ensley serves one of the faster-growing communities on the Escambia County mainland. Ensley's population rose 15.6 percent between 2010 and 2020, from 20,602 to 23,817, and the 2020 census counted 11,018 housing units. US 29, US 90 Alternate and Interstate 10 all run through the community, so it draws families and commuters who want easy access to the rest of the metro area. That mix of older houses and newer construction means the insulation needs vary block by block.

Higher ground, same humidity

At an elevation of about 128 feet, Ensley sits higher than the bayside neighborhoods to the south, but the air is just as humid in summer. Escambia County is in IECC Climate Zone 2A, the warm-humid zone, and the work here is about keeping hot, damp air out of the house and keeping attic heat away from the rooms below. Houses on a slab with the air handler in the attic are the most common setup we see.

Two plans for the attic

For a simple attic where the ducts are in good shape, we seal the ceiling gaps and blow cellulose or fiberglass to depth. For an attic packed with ductwork, or one where the ducts sweat and drip, foam on the underside of the roof deck usually makes a bigger difference because the ducts then run in milder air. We lay out both when both fit and let you choose.

Newer homes with hot spots

Newer houses in Ensley meet more recent codes, but owners still call about upstairs rooms that run warm, bonus rooms over garages and vaulted ceilings. The cause is often a short list of gaps: an unsealed kneewall, loose batts in the garage ceiling, a soffit over the kitchen cabinets that opens into the attic. Foam closes those spots for good.

Storm history

Ensley has felt the same hurricanes as the rest of the Pensacola area, including Frederic in 1979, Ivan in 2004 and Sally in 2020. If a roof was damaged and the attic took on water, the insulation should come out and the framing should dry before new insulation goes in. We write removal and replacement as separate lines, which also helps with insurance paperwork.

Budget numbers

HomeGuide lists open-cell spray foam at $1.50 to $3.50 per square foot and closed-cell at $3.00 to $5.00, and blown-in at $1.00 to $2.80 per square foot. Those are national ranges, but they show why the attic approach matters: foaming a whole roofline can cost several times what sealing and blowing in an attic floor costs. In Ensley homes where the ducts are in good shape, the blown-in route often makes sense. Where the attic is full of ductwork, the foam route usually pays back in comfort. The written estimate after we look is the price.

Older houses

Ensley's population was already 14,422 in 1980, so plenty of its homes are decades old. Those attics often have a few inches of settled fill and the original ducts. Sealing and bringing the attic to depth is usually the first job.

Call or send the form and we will set a time to look. Get a free estimate